Cummins series genset 20KW-1500KW
Benz series Genset 570KW-2200KW
Volvo series Genset 68KW-500KW
Daewoo series Genset 220KW-550KW
Weichai series Genset 20KW-200KW
Shangchai series Genset 50KW-500KW
MWM series Genset 400KW-1600KW
Jichai series Genset 800KW-2000KW
Wudong series Genset 200KW-600KW
Tongchai series Genset 150KW-600KW
Soundproof type Genset 15KW-2000KW
Automatic type genset 15KW-2000KW
Mobile power station 15KW-2000KW
Marine generator set
Gas Generator Set
Clutch and generators
Small generators 5KW-15KW
Gasoline Generator 1KW-6KW
Add:Shandong Weifang kuiwen district weizhou road 673 (Jinli building)
Sales Tel:+86 0536-8235905 8228717
Fax:+86 0536-8235905 8228717
Mob:+86 13853615967(Mr.Wang)
Service:+86 0536-7599876 
Support:+86 13335258000 (Mr.Zhu)

Automatic type genset(15KW-2000KW)

Automatic type genset


Manual control panel (standard settings)
Proving with the basic start-up/stop function
Possessing the following basic settings and functions
Start-up/stop controller
Three phase AC current meter
Voltage meter and selection switches
Frequency meter/water temperature meter/oil temperature meter/time gauge/battery voltage
urgency stop button
Alarms: over speed, high water temperature,low oil temperature,charging failure.
Protection:low oil pressure,high water temperature,over speed,emengency stop,and other pre-set protections.
2.Non power supply(loss pressure)auto-start-up control screen
Except the standard manual controlled panel function and settings.this one is equipped with the additional control interfaces.
Automatic/stop/manual function selection
Start-up delay relay (3-5seconds,adjustable)
Break down delay relay( 0-270seconds,adjustable )
Three times self-automatic start-up time relay
Additional power supply charger alarming indicator: low/over speed,output voltage faults,star-up failure,high water temperature pre-alarming,emengency stop
Additional: low/over speed,start-up failure,output voltage faults(over voltage,voltage shortage,over current)
Full automatic remote monitoring control panel
LCD screen shows the operational sequences,working status,faults as all the parameters.
With interfaces of RS232 OR 485,and the function of remote control,remote measuring and remote comunication,with unit protection,and auto stop and alarming function under certain circumatances such as start-up failure,over speed,low speed,high water temperature,low oil pressure,no signal for the speed sensors,breakdowns of electrical charging etc.
4.Automatic transmission switch(ATS)
Four polar mechnical/electrical interlock switch over switches
Power supply,power generatation,and indicator with load condition
Automatic/manual control screen
The screen itself has been picked,phosphorized and plastic injected
Leaving for reserved sufficient room, convenient for cable laying
Automatically  switch over time,not more than 7seconds(adjustable)
5.Non-duty staff,independent auto control panel
According to the requirements of our customers,we supply a type of independent control cabinet,which integrates the functions of automatic start-up for controlling and self-loading;such control cabinet is very easy to operate,suitable for the electrical concentration control of all the related electrical equipment.
6.Parallel control panel
Functions of Manual/semiautomatic/automatic for two machines or multiparallel,which forms a a power supply network,more reliable for power supply.
Centralized control commanding,automatically distributes the load,to enable the maintenance and repair work more convenient.
More economical, the amount of running units can be put into use according to the necessity of actualloads,which can save the operational cost for the customers.
More flexible for the future expansion,customers can add equipment at any time according to the nacessity of the development, to meet with the requirement of additional loads.


Automatic type genset(15KW-2000KW) 2009-11-25 本文被阅读 4624 次
   homepage | profile | products | case | message | service | contact us
Copyright:weifang vovac electromechanical power co.,ltd.